seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Installing > < Renewing seal for right flange shaft

Leon Mk2

Removing
Removing
–  Remove noise insulation tray → General body repairs, exterior; Rep. Gr.66.
–  Turn steering to right to full lock.
–  Remove drive shaft → Running gear, axles, steering front and four-wheel drive; Rep. Gr.40.
   
–  Disconnect left and right coupling rods from anti-roll bar -arrow-.
–  Turn anti-roll bar slightly upwards.
–  Place drip tray under gearbox.
–  Lever out sealing cover in right flange shaft, if present, with a screwdriver.
  Note!
Sealing cover will not be reinstalled and therefore does not need to be renewed.
–  Remove right flange shaft bolt with socket -T10107 A-.
–  Pull out right flange shaft with compression spring and thrust washer.
–  Lever out seal using a screwdriver.
  N40-0099

Installing > < Renewing seal for right flange shaft