seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Tightening torques > < Removal:

Leon Mk2

Installation
Installation
Installation is carried out in the reverse sequence; note the following:
–  Renew cut cable ties.
   
–  Press in pipe and hose assembly -1- with new seal -2- in master cylinder connection -4- until safety fastener -3- is audibly secured.
–  Pull pipe and hose assembly to check it is properly secured.
–  Install crash bar.
–  Fit the footwell area vent, the cable guide, driver's side cover → Rep. gr.68.
–  Fit the battery support, the battery cover and the battery → Rep. gr.27.
–  Bleed clutch system → Chapter.
–  Fit the complete air filter housing → Rep. gr.24 and → Rep. gr.23.
  A30-0156

Tightening torques > < Removal: