SEAT Workshop Service and Repair Manuals > Leon Mk2 > 6-speed manual gearbox 02Q, all-wheel drive | Clutch, control | Clutch mechanism: repairs | Removing and installing over-centre spring

Installation

Installation is carried out in the reverse sequence; note the following:

Note

Grease all bearings and contact surfaces with lubricating grease → Spare Spare parts catalogue.

–	Position clutch pedal over-centre spring -4- on support stand -3-, at the same time lightly pressing upper part of clutch pedal -1- towards master cylinder and against neutral over-centre spring, until bolt can pass through -5- and tighten nut -2- firmly. → Item

–	Fit the support stand . Tightening torque → Item

–	Hydraulic clutch system: bleeding of air → Chapter.

SEAT Workshop Service and Repair Manuals