seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Slave cylinder: removing and installing > < Clutch release assembly, pump: repairs

Leon Mk2

Clutch release assembly, pump: general fitting diagram
   
Clutch release assembly, pump: general fitting diagram
1 -  12 Nm
q   3 units
q   Replacement
2 - Clutch slave cylinder with clutch release collar
q   The slave cylinder and the clutch release collar make up one unit and may only be replaced together
q   Do not wash the collar. Only clean it with a cloth
q   Change the collar along with the slave cylinder if they make too much noise
q   Removing and installing → Chapter
3 - O–ring
q   Replacement
4 - Security fastener
q   Always replace
5 - Air bleed plug -4.5 Nm
6 - Protection hood
7 - Security fastener
8 - Pipe and hose assembly
q   For the clutch pump
q   Removing and fitting to the air bleeder valve → Fig.
9 - O–ring
q   Replacement
10 - Air bleeding valve
q   Removing and fitting → Fig.
11 - Input shaft seal
q   Replacement → Chapter

   
Removing and installing pipe and hose assembly on the clutch slave cylinder
–  To remove, the release the safety fastener -2- with a screwdriver then unscrew and disconnect the air bleeder valve -4- from the slave cylinder -1-.
  Note
  A30-0136
When removing the hose assembly or master cylinder, use the hydraulic seal adapters to avoid liquid leaking onto the body.
–  For installation a new O-ring -3- must be fitted to the slave cylinder. Insert the air bleeder valve into the slave cylinder connection until the attachment clip is connected with an audible click.
–  Pull on the air bleeder valve to ensure that it is correctly secured.
  E30-10004
Removing and fitting the air bleeder valve on the slave cylinder
–  To remove, the release the safety fastener -2- with a screwdriver then unscrew and disconnect the air bleeder valve -4- from the slave cylinder -1-.
–  For installation a new O-ring -3- must be fitted to the slave cylinder. Insert the air bleeder valve into the slave cylinder connection until the attachment clip is connected with an audible click.
  A30-0137

Slave cylinder: removing and installing > < Clutch release assembly, pump: repairs