seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Torque settings > < Removing

Leon Mk2

Fitting
Fitting
   
Installation is carried out in the reverse order; noting the following:
  Note
Replace the O-rings.
–  Press in pipe and hose assembly -1- with new O-ring -2- in master cylinder connection -4- until securing clip -3- is audibly secured.
–  Pull on the pipe and hose assembly to check it is properly secured.
–  Press in pipe and hose assembly -4- with new O-ring -3- on the bleeder valve connection -1- until securing clip -2- is audibly secured.
  A30-0138
–  Pull on the pipe and hose assembly to check it is properly secured.
–  Bleed air from hydraulic clutch system → Chapter.
–  Fit the battery → Rep. Gr.27.
  A30-0136

Torque settings > < Removing