Unlock retaining element -A- for selector and shift cable -B- as follows:
–
Press moveable sleeve forwards as far as it will go -arrow 1-.
–
Move as far as possible -arrow 2- and turn right to fix it in place.
Note
The control cable -B- must be able to move in its securing element.
l
Gearbox in „neutral“
Immobilise the gear selection shaft as follows:
–
Shift the gear mechanism -1- in the direction of -arrow A- until it is in the track for the 1st and 2nd gear. Simultaneously turn locking pin-2- toward -arrow B- and shift. This blocks the gear mechanism.
The gear selection shaft will then remain immobilised and you will not be able to move it.
–
Ensure that the selection and gear control cables -B- are well secured and without tension in the securing element -A-.
–
Slacken moveable sleeve -arrow 1-.
–
Slide the moveable sleeve to the limit -arrow 2-.
The control cable is now adjusted.
–
Extract the locking pin from the gearbox in order to release the gear control mechanism.
–
Remove counterhold -T10027A- from gear selector mechanism.
–
Gear lever knob, checking the adjustment → Chapter.