| t
| Loosen bolts and nuts in reverse of tightening sequence. |
| t
| The bolts and nuts to be used to secure covers and casings must be released and tightened diagonally in stages when no tightening order is specified. |
| t
| Always replace self-locking nuts and bolts. |
| t
| The torque settings are valid for non-oiled nuts and bolts. |
| t
| Threaded holes where there had been self-locking bolts or bolts with thread fixing agent must first be cleaned (for example, with a threading male). If this is not done, the bolts may break when removed again. |
| t
| In all bolted unions, ensure that supporting surfaces and bolts and nuts are only waxed after installation, if this is necessary. |
|
|
|
