Leon Mk2
Clutch release assembly, slave cylinder - Installation overview |
1 - | Bolt, 12 Nm |
q | 3 off |
q | replace |
q | Carefully tighten cross-wise and one after another so that the threaded bores of the cylinder do not break. |
2 - | Slave cylinder with clutch release bearing |
q | The slave cylinder and the clutch release collar make up one unit and may only be replaced together |
q | Do not wash out the bearing. Wipe it only with a cloth |
q | Change the collar along with the slave cylinder if they make too much noise |
q | removing and fitting → Chapter |
q | For some slave cylinders, divided supply line → Fig. |
q | Several versions of the release bearing have an additional plastic plate → Fig. and the pressure plate has been adapted → Fig. |
q | For correct version refer to → Electronic parts catalogue „ETKA“ |
3 - | O ring |
q | replace |
4 - | Securing clip |
q | Always replace. |
5 - | Air bleed plug -4.5 Nm |
6 - | Protective cap |
7 - | Securing clip |
8 - | Pipe and hose assembly |
q | To master cylinder |
q | Removing and installing a bleeder screw → Fig. |
9 - | O ring |
q | replace |
10 - | Vent valve |
q | removing and fitting → Fig. |
11 - | Join ring for the input shaft |
q | Replace → Chapter |
|
|
|