Leon Mk2
Note
|
1 - | Selector mechanism cover |
q | removing and fitting → Fig. |
2 - | The gear selection mechanism |
q | removing and fitting → Fig. |
3 - | Thrust piece |
q | will not be installed on plastic reversing lever |
4 - | Retainer washer |
q | Removing → Fig. |
q | will not be installed on plastic reversing lever |
5 - | Seal |
q | Replace → Chapter |
6 - | Retainer washer |
7 - | Gear selector cable |
8 - | 25 Nm |
q | Self-locking |
q | replace |
9 - | Gearbox selector lever |
q | Can only be installed in one position |
10 - | Retainer washer |
q | will not be installed on plastic reversing lever |
11 - | Selection control cable |
12 - | Return lever |
q | Once fitted, adjust the gear operation mechanism → Chapter |
q | May be plastic or metallic |
q | The plastic reversing lever does not block the bearing bushings -3 and 14- of lock washer -4 and 10- |
13 - | Sliding piece |
14 - | Thrust piece |
q | will not be installed on plastic reversing lever |
15 - | Locking pin |
q | For adjusting selector mechanism → Chapter |
|