SEAT Workshop Service and Repair Manuals

Operation process

Pulling off deep groove ball bearing –  Remove the input shaft securing ring. –  Before fitting the adapter -U-40100/1-, the adapter -U-40200/3- and the adapter -U-40100/7- with adapter -U-40100/4- must be fitted to the input shaft.

Press out the mobile pinion for 5th gear –  Place the adapter -U-40100/3- under the mobile pinion for the 5th gear.

Press in the mobile pinion for 5th gear –  Fit the input shaft in a vice with the pressure tool -T20141- and insert the adapter -U-40200/13- and the adapter - U-40200/18 -.

Pressing on deep groove ball bearing l  Insert the ball bearing: Installation position The housing for the retaining ring must point upwards, the recess must point to the mobile pinion for 5th gear. –  Fit ball bearing with socket -U-40200/19 -. –  Determine the securing ring → Fig. and fit it.

Determining thickness of circlip –  Attach a retaining ring -A- with a thickness of 1.86 mm on the drive shaft, shift the shaft toward the top of the bearing. –  Measure the distance between the ball bearing -B- and the securing ring fitted -A- using a gauge -C- –  Remove the securing ring fitted for the measurement. –  Determine the securing ring according to the table → Spare parts catalogue. The following retaining rings are available:

Measured value (mm)	Retaining ring thickness (mm)	Axial play (mm)
0,01 … 0,05	1,86	0,01 … 0,05
0,05 … 0,07	1,89	0,01 … 0,05
0,07 … 0,10	1,92	0,01 … 0,05
0,10 … 0,13	1,95	0,01 … 0,05
0,13 … 0,16	1,98	0,01 … 0,05

Extract the roller bearing from the clutch housing –  To extract the cylindrical roller bearings from the housing, press on the securing ring using a pliers -C-. –  Extract the bearing sockets using the adapter -T20140/1- and the pressure tool -T20140/30 - .

Pressing cylindrical roller bearing into clutch housing –  When inserting, the securing ring must be pressed -arrow- from the cylindrical roller bearing using some pliers -A- and using the adapter -U-40450/3- and the adapter -U-40450/9 -. –  Remove the pliers before leaving the roller bearing in installation position. l  The securing ring should insert into the groove of the clutch housing