seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Clutch pedal: Removing and installing|Installation > < Clutch pedal: Removing and installing

Leon Mk2

Removal:
Removal:
l  Clutch pedal support stand removed → Chapter.
–  Move pedal to highest position. Take care that over-centre spring does not jump out of neutral.
  Note
   
When the securing bolt is removed from the clutch pedal, take the precaution of lightly holding the clutch pedal so that it does not jump out of neutral.
–  Disconnect clutch pedal -1- from the assembly support holder -3- . To do so the nut -2- must be unscrewed, the clutch pedal must be slightly pressed, the screw -5- must be loosened and at the same time the over centre spring -4- must be removed.
  A30-0125
–  Clutch pedal is held by safety clip onto master cylinder actuating rod.
  E30-10013
–  With bolt -arrow- removed, release clutch pedal from rod with pliers -T20059B-.
  E30-10001
–  The points of the pliers -T20059B- have been prepared to the specified dimensions: left hand side 7.5 mm and right hand side 3.5 mm.
–  Remove clutch pedal.
  E30-10011

Clutch pedal: Removing and installing|Installation > < Clutch pedal: Removing and installing