SEAT Workshop Service and Repair Manuals > Leon Mk2 > 6-speed manual gearbox 02S | Clutch, control | Clutch action | Over-centre spring: Removing and installing

Installation

Installation is carried out in the reverse sequence; note the following:

Grease all bearing bushes and contact surfaces, according to → Spare parts catalogue.

–	Position clutch pedal over-centre spring -4- on support stand -3-, at the same time lightly pressing upper part of clutch pedal -1- towards master cylinder and against neutral over-centre spring, until bolt can pass through -5- and tighten nut -2- firmly.

–	Install clutch pedal support stand → Chapter.

–	Bleed air from hydraulic clutch system → Chapter

SEAT Workshop Service and Repair Manuals