seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Installing > < Sealing ring, right side and sleeve: Renewing with the gearbox installed (the seal of the flange shaft and sleeve are carried ou

Leon Mk2

Detaching
Detaching
–  Remove noise insulation → General body repairs, exterior; Rep. gr.50.
–  Turn steering to full right lock.
   
–  Remove drive shaft heat shield, if present -arrows- → Running gear, axles, steering; Rep. gr.40.
  N34-11369
–  Disconnect drive shaft -1- from flange shaft → Running gear, axles, steering; Rep. gr.40.
–  Tie-up drive shaft as high as possible. Do not damage paint on drive shaft.
–  With some engines, the drive shaft cannot be raised and secured high enough that the flange shaft can be pulled out.
–  Then remove the cardan shaft → Running gear, shafts, steering; Rep. gr.40.
–  Place drip tray under gearbox and engine.
–  Unbolt turbocharger oil return line from engine -arrow- → Rep. gr.21.
  N39-0824
–  Extract the bolt fastening the flanged shaft. To do so, thread two bolts on the flange and lock the shaft using the assembly lever.
–  Remove flanged shaft together with compression spring.
  V34-2737
–  Pull out oil seal with sleeve.
A projection is located on inside diameter of sleeve.
–  Position puller hook -VW 771/37- directly behind projection in sleeve.
–  During this operation, press puller hook -VW 771/37- firmly in against sleeve.
  N39-1187

Installing > < Sealing ring, right side and sleeve: Renewing with the gearbox installed (the seal of the flange shaft and sleeve are carried ou