Leon Mk2
Input shaft, layshaft (thrust pinion shaft), differential and gear prongs: Removing and installing |
1 - | Differential |
q | Dismantling and assembling → Chapter |
2 - | Seal |
q | 4x |
q | Always replace |
3 - | Output shaft |
q | Dismantling and assembling → Chapter |
4 - | Reverse gear shaft support |
q | Dismantling and assembling → Chapter |
5 - | Reverse shaft |
q | With »selector gear for reverse« |
t | Dismantling and assembling → Chapter |
q | With »locking collar for reverse« (with several gearboxes, from manufacture date, week 22/2010) |
l | Dismantling and assembling → Chapter |
6 - | Input shaft: |
q | Dismantling and assembling → Chapter |
7 - | Selector fork for reverse gear |
q | Only in conjunction with »selector gear for reverse« |
t | Dismantling and assembling → Chapter |
q | Only in conjunction with »locking collar for reverse« |
t | Selection of the reverse gear is then via the selector plates → Item |
8 - | Torx socket head bolt, 25 Nm |
9 - | Gear selection mechanism |
q | (Selector forks) |
q | In conjunction with »selector gear for reverse« |
t | Dismantling and assembling → Chapter |
q | In conjunction with »locking collar for reverse« (with several gearboxes, from manufacture date, week 22/2010) |
t | Dismantling and assembling → Chapter |
10 - | clutch housing |
q | Repairs → Chapter |
11 - | Hexagonal nut, tighten to 25 Nm + 1/4 turn (90°) |
q | 4 bolts for the bearing allotment |
12 - | Flange shaft with compression spring |
q | Removing and installing → Chapter>>>>>>>> |
13 - | 25 Nm conical bolt |