SEAT Workshop Service and Repair Manuals

Sealing ring with control unit: replace Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Extractor kit -T20143-, see equivalent → Anchor

t  Tappet -T20153-, see equivalent → Anchor Operation process –  Disconnect the battery earth strap.   Note Observe the safety measures to be adopted when disconnecting the battery → Electrical system; Rep. gr. 27 –  Remove engine cover → Booklet101. –  Remove the air filter body, breather hose and air duct hoses → Rep. gr.24 and → Rep. gr.23 .

–  Remove the battery → Electrical system; Rep. gr.27 . –  Remove battery tray -arrows- and remove from vehicle. Metal idler rod

–  Detach safety clip -4- and, applying pressure, extract idler rod to one side -3-, removing it from its housing. Plastic idler rod: –  Remove the idler rod together with the cable fastener → Chapter Continued for all vehicles

–  Unscrew nut -2- and remove selector rod -1-.

–  Remove seal by levering with extractor -T20143/1-.

–  Fit seal with tappet -T20153-. The remaining installation steps are carried out in reverse sequence - note the following points:   Note The selector rod may only be placed in one position. Tightening torque → Item –  Install battery → Electrical system; Rep. gr.27.