Leon Mk2
Note
|
1 - | clutch housing |
2 - | Axial/radial needle bearing |
q | Removing → Fig. |
q | After installation, the axial/radial needle bearing must always be replaced. |
q | Installing → Fig. |
3 - | Reverse gear |
4 - | Circlip |
q | Use pliers -A-81124- to remove the safety ring. |
q | Always replace |
5 - | Selector gear for reverse gear |
q | The locking ring has to be removed before installing |
q | Installation position: the pinion collar must face pinion of reverse gear |
6 - | Reverse gear shaft |
q | Removing and installing → Chapter |
7 - | Axial/radial needle bearing |
q | Removing → Fig. |
q | After removal, the axial/radial needle bearing must always be replaced. |
q | Installing → Fig. |
8 - | Reverse shaft support |
q | Removing and installing → Chapter |