seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling procedure > < Assembly overview - removing and installing input shaft, output shafts, differential, bevel box and selector rods

Leon Mk2

Securing gearbox to assembly stand
Securing gearbox to assembly stand
  Note
Refer to procedure for required special tools „Installation sequence“ → Chapter.
   
Gearbox for all-wheel drive in conjunction with turbo diesel engine
To be able to secure the gearbox to the gearbox support -VW 353-, the bevel box must be removed:
–  Unscrew securing bolts on insert axle on the right using the hexagon socket -T10107A-; during operation the insert axle must be locked.
–  Remove 4 connecting bolts -arrows- for bevel box to gearbox (only 3 are visible in figure).
–  Carefully press bevel box off gearbox, taking care that it does not fall.
  N34-11677
Turbo diesel engine gearbox
  N34-11009
–  Secure the gearbox with bolts -arrows- to the gearbox support -VW 353-.
–  Use holes -1- and -2- for this.
  N34-10962

Dismantling and assembling procedure > < Assembly overview - removing and installing input shaft, output shafts, differential, bevel box and selector rods