Leon Mk2
| Assembly overview - gearbox housing |
Note| If tapered roller bearing is renewed, install new shims of the same thickness as the old ones. |
| 1 - | Gearbox housing |
| 2 - | Seal |
| q | Always renew |
| 3 - | Oil filler plug |
| q | Torque setting ⇒ Checking gear oil in gearbox → Chapter |
| 4 - | Bolt, 35 Nm |
| q | Threaded hole for bolt is then closed |
| q | Alhambra: does not feature this |
| 5 - | Bearing bush |
| q | For selector shaft |
| q | Pulling off → Fig. |
| q | Driving in → Fig. |
| 6 - | Bearing bush |
| q | For selector rod |
| q | Pulling off → Fig. |
| q | Driving in → Fig. |
| 7 - | Shim |
| q | For output shaft for 3rd and 4th gear |
| q | Note thickness |
| q | Will be damaged when removed; renew |
| 8 - | Tapered roller bearing outer race |
| q | For output shaft for 3rd and 4th gear |
| q | Removing and installing → Item |
| q | In the case of replacement: install a shim → Item of the same thickness |
| 9 - | Shim |
| q | For output shaft for 1st and 2nd gear |
| q | Note thickness |
| q | Will be damaged when removed; renew |
| 10 - | Tapered roller bearing outer race |
| q | For output shaft for 1st and 2nd gear |
| q | Removing and installing → Item |
| q | If replaced: install a shim → Item of the same thickness |
| 11 - | Tapered roller bearing outer race |
| q | For the differential |
| q | Removing and installing → Item |
| q | If replaced, adjust the differential → Chapter |
| 12 - | Shim |
| q | For the differential |
| q | Adjusting differential → Chapter |
| 13 - | Tapered roller bearing outer race |
| q | For reverse gear output shaft |
| q | Removing and installing → Item |
| q | If replaced: install a shim of the same thickness |
| 14 - | Shim |
| q | For reverse gear output shaft |
| q | Note thickness |
| q | Will be damaged when removed; renew |
| 15 - | Electromagnet |
| q | Glue into gearbox housing with sealing paste -AMV 188 200 03-. |
| 16 - | Oil drain plug, 45 Nm |
| 17 - | Seal |
| q | replace with gearbox installed → Chapter |
