SEAT Workshop Service and Repair Manuals

Assembly overview - Selector cables

t	Lubricate bearing positions and sliding surfaces.

t	Allocate grease using → Electronic parts catalogue (ETKA).

t	Do not kink selector cables.

1 -	Gear selector cable

q	Use cable tie to fix onto gate selector cable → Fig.

q	Connect to cable end-piece → Item

q	Installation position → Chapter

2 -	Gate selector cable

q	Connect to cable end-piece → Item

q	Installation position → Chapter

q	Use cable tie to fix onto gear selector cable → Fig.

3 -

Sleeve

4 -	Selector housing

5 -

Circlip

q	Do not damage cable when removing

q	Always renew

6 -

Circlip

q	Do not damage cable when removing

q	Always renew

7 -

Circlip

q	Do not damage cable when removing

q	Always renew

8 -	Hexagon bolt, 20 Nm

q

3 off

q	For cable support bracket

9 -	Cable support bracket

10 -

Sleeve

q	Cable support bracket mounting on gearbox

11 -

Spacer

12 -	Cable end-piece

q	After installing, adjust selector mechanism → Chapter

q	For gear selector cable to gearbox selector lever

q	Do not mix them up. Cable end-pieces for gate selector cable to relay lever and gear selector cable to gearbox selector lever are different.

q	Allocation → Fig.

13 -

Circlip

q	Always renew

q	Removing → Fig.

14 -	Cable end-piece

q	After installing, adjust selector mechanism → Chapter

q	For gate selector cable to relay lever

q	Do not mix up. Cable end-pieces for gate selector cable to relay lever and gear selector cable to gearbox selector lever are different.

q	Remove from relay lever → Fig.

q	Press onto relay lever → Fig.

q	Allocation → Fig.

15 -	Hexagon nut 23 Nm

q	Always renew

16 -	Selector lever

q	with balancing weight

q	Installation position → Fig.

q	Installing → Fig.

q	After installing, adjust selector mechanism → Chapter

17 -	Relay lever

q	Installation position → Fig.

q	Shortly after start of production: secured by a clip → Fig.

q	Remove → Fig. and install → Fig. relay lever together with cable end-piece

q	After installing, adjust selector mechanism → Chapter

18 -	Sliding piece

Using cable tie to secure gear selector cable and gate selector cable –  Wind cable tie -arrow- around the selector cables in a figure eight and secure them as shown in figure. -A- = Gear selector cable -B- = Gate selector cable

Levering cable end-piece for gate selector cable off relay lever l  Relay lever has been removed –  Insert a flat-blade screwdriver -A- between bush -B- and relay lever.

Pressing on cable end-piece l  Relay lever has been removed l  Cable end-piece may be pressed only onto bush -arrow-. l  Cable end-piece must move freely on relay lever.

l  It must be located behind fastener -arrow 2-

Allocation of cable end-pieces

Cable end-piece for	Dimension „a“
1. - Gear selector cable to gearbox selector lever	8.5 mm
2. - Gate selector cable to relay lever	10 mm

Installation position of gearbox selector lever and relay lever 1 -  Gear selector lever with balancing weight 2 -  Relay lever engages in guide rail of gearbox selector lever via shoe -arrow-.

Fit the idler rod –  When fitting the gearbox selector lever, ensure that the gap -arrow A- is aligned with the master spline -arrow B-.

Removing lock washer –  Lift tab in -direction of arrow-.