Leon Mk2
Assembly overview - hydraulics (RHD) |
1 - | Brake fluid deposit |
2 - | Seal |
q | The seals must be located in supply hose |
3 - | Circulation hose |
4 - | Master cylinder |
q | Removing and installing → Chapter>>>>>>>> |
5 - | Clip |
q | To remove and install pipe, pull out clip as far as it will go |
6 - | Seal / O-ring |
q | Pull onto line connection |
q | Lubricate with brake fluid before installing |
q | Seals/O-rings are adapted to configuration of line connection → Fig. |
q | Assignment → Electronic parts catalogue „ETKA“ |
7 - | Mounting |
q | To remove and install, separate master cylinder from clutch pedal → Chapter. |
8 - | Clutch pedal |
q | Removing and installing → Chapter>>>>>>>> |
9 - | Hexagon nut → Item |
10 - | Spring retainer |
q | Fixed onto the bodywork |
11 - | Pipe line |
q | Pipe and hose/pipe line → Item may be in one piece |
q | Assignment → Electronic parts catalogue „ETKA“ |
q | To remove, remove battery and battery tray → Electrical system; Rep. gr.27. |
12 - | Seal / O-ring |
q | Pull onto line connection |
q | Lubricate with brake fluid before installing |
q | Seals/O-rings are adapted to configuration of line connection → Fig. |
q | Assignment → Electronic parts catalogue „ETKA“ |
13 - | Pipe and hose assembly |
q | Pipe → Item and hose/pipe line may be in one piece |
q | Assignment → Electronic parts catalogue „ETKA“ |
q | To remove, remove battery and battery tray → Electrical system; Rep. gr.27. |
14 - | Seal / O-ring |
q | Pull onto line connection |
q | Lubricate with brake fluid before installing |
q | Seals/O-rings are adapted to configuration of line connection → Fig. |
q | Assignment → Electronic parts catalogue „ETKA“ |
15 - | Clip |
q | To remove and install pipe/hose assembly or bleeder connection, pull out clip as far as it will go. |
16 - | Vent valve |
q | Bleed the clutch system → Chapter. |
17 - | Grease cap |
18 - | Bleeder connection |
19 - | Seal / O-ring |
q | Pull onto line connection |
q | Lubricate with brake fluid before installing |
q | Seals/O-rings are adapted to configuration of line connection → Fig. |
q | Assignment → Electronic parts catalogue „ETKA“ |
20 - | Slave cylinder |
q | Can only be renewed after removing gearbox |
q | Removing and installing, ⇒ Repairing clutch release mechanism, → Chapter |
21 - | Gearbox: |