Leon Mk2
III - Assembly overview - removing and installing selector cables |
Note
t | Lubricate bearing positions and sliding surfaces. |
t | Allocate grease using → Electronic parts catalogue (ETKA). |
1 - | Gear selector cable |
q | Connect to cable end-piece → Item |
q | Installation position → Chapter |
2 - | Selection control cable |
q | Connect to cable end-piece → Item |
q | Installation position → Chapter |
3 - | Drift sleeve |
4 - | Lever protection box |
5 - | Retainer washer |
q | Take care not to damage selector cables when removing. |
q | Always renew |
6 - | Hexagon bolt, 20 Nm |
q | Qty. 3 in vehicles with petrol engine |
q | In vehicles with turbo diesel engine, cable support bracket secured with 2 hexagon bolts and one hexagon nut, 20 Nm |
7 - | Retainer washer |
q | Take care not to damage selector cables when removing. |
q | Always renew |
8 - | Cable support bracket |
q | In some selector mechanisms, cable support bracket secured with 2 hexagon bolts and one hexagon nut |
9 - | Grommet |
q | Cable support bracket mounting on gearbox |
10 - | Spacer |
11 - | Cable attachment |
q | After installing, adjust selector mechanism → Chapter |
q | For gate selector cable to relay lever |
q | Do not interchange! Cable end-pieces for gate selector cable to relay lever and gear selector cable to gearbox selector lever are different. |
q | Remove and install together with relay lever → Chapter |
q | Removing → Fig. |
q | Pressing on → Fig. |
q | Allocation → Fig. |
12 - | Return lever |
q | Installation position → Fig. |
q | Remove and install → Chapter relay lever together with cable end-piece |
q | If there is a hole -arrow- in bearing shaft, press in clip → Item |
q | After installing, adjust selector mechanism → Chapter |
13 - | Wiring clip |
q | For relay lever with hole -arrow- in bearing shaft of relay lever |
14 - | Runner |
15 - | Gearbox selector lever |
q | Installing → Fig. |
q | Installation position → Fig. |
q | After installing, adjust selector mechanism → Chapter |
16 - | Self-locking hexagon nut, 23 Nm |
q | Always renew |
17 - | Cable attachment |
q | After installing, adjust selector mechanism → Chapter |
q | Secures gear selector cable to gearbox selector lever |
q | Do not mix up. Cable end-pieces for gate selector cable to relay lever and gear selector cable to gearbox selector lever are different. |
q | Allocation → Fig. |
18 - | Retainer washer |
q | Always renew |
|
Cable end-piece for: | Gap „a“ |
1. - Gear selector cable to gearbox selector lever | 8.5 mm |
2. - Gate selector cable to relay lever | 10 mm |
|
|
|