Leon Mk2
|
1 - | Output shaft 2 |
2 - | Needle thrust bearing |
3 - | Needle bearing |
4 - | Reverse gear pinion |
5 - | Plate |
6 - | Locking collar and synchro-hub for 6th gear |
q | Dismantling and assembling → Chapter. |
7 - | Synchro-ring |
8 - | Needle bearing |
9 - | Needle bearing bush |
10 - | Mobile pinion of 6th gear |
11 - | Plate |
Note
Output shaft is assembled as far as this washer for purpose of adjusting shaft. |
12 - | Needle bearing |
13 - | Needle bearing bush |
14 - | 7th gear mobile pinion |
15 - | Synchro-ring |
16 - | Locking collar and synchro-hub for 5th and 7th gears |
q | Dismantling and assembling → Chapter. |
17 - | Synchro-ring |
18 - | Needle bearing |
19 - | Needle bearing bush |
20 - | 5th speed selector gear |
21 - | Support |
q | Removing and installing → Anchor>>>>>>>> |
Note
Always renew the bearings on a shaft together. |
22 - | Bolt. |
q | Removing → Chapter |
q | Installing and torque setting → Chapter |
– | Always replace. |
23 - | Bearing cap |
q | Removing and installing → Chapter>>>>>>>> |
l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
24 - | Bearing cap |
q | Removing and installing → Chapter>>>>>>>> |
l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
25 - | Support |
q | Pressing out → Anchor |
q | Pressing on → Anchor |
Note
Always renew the bearings on a shaft together. |