| The mechatronic detects the other control units in the vehicle via the signal if the databus. |
| The mechatronic adapts important functions with this procedure. Important configurations and programmed values are also taken over again. In this manner the synchronisation points and the »reference points« for the shift lever and the gearshift mechanisms can be adapted. |
| –
| The option Complete basic setting may not be selected: |
WARNING | Do not carry out basic adjustment without a reason unless requested to do so! |
|
| t
| when this is requested in the „Guided Fault Finding“, |
| t
| after correcting a registered fault, |
| t
| after fitting another gearbox, |
| t
| after fitting a clutch or |
| t
| after fitting a mechatronic. |
|
|
|
