seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Determining shaft bevel gear installation position (actual measurement) > < Position of shims

Leon Mk2

Automatic gearbox 099 four-wheel drive
Adjusting bevel gear and shaft bevel gear (gear set)
Adjustment overview (rear final drive)

If repairs have been carried out to the final drive it is only necessary to adjust the shaft bevel gear, bevel gear or complete gear set if components have been renewed which have a direct effect on the adjustment of the final drive. Refer to the following table to avoid unnecessary adjustment:

to be adjusted:

Shaft bevel gear
(S3)
via deviation "r"

Bevel gear
(S1 and S2)

=> Page 39-207

Part replaced:

Pinion housing

x

Rear axle housing

x

x

Gear set
(Shaft bevel gear and bevel gear with input shaft)

x

x

Shaft bevel gear taper roller bearing

x

Bevel gear taper roller bearing

x

Cover

x1)

1)    Only S1 via previously measured complete friction moment.

Determining shaft bevel gear installation position (actual measurement) > < Position of shims