SEAT Workshop Service and Repair Manuals

1)    Adjustment work is required if these components are replaced => Adjustment overview Page 39-193.

• Rear axle housing1)
• Input shaft bevel gear1)
• ◆ For rear final drive without differential lock
• ◆ Bevel gear is paired with shaft bevel gear
• ◆ Allocate according to gearbox code letters using parts catalogue
• ◆ Servicing input shaft bevel gear bearing => Page 39-175

• O-ring
• ◆ Always renew
• Cover1)
• ◆ Removing => Page 39-145
• ◆ Pressing in => Page 39-146
• Circlip
• ◆ Always renew
• ◆ Removing and installing => Page 39-120
• Output shaft drive flange
• ◆ For rear final drive without differential lock
• ◆ Removing => Page 39-143
• ◆ Drive in with synthetic head hammer
• ◆ Separating and connecting output shaft and drive flange => Page 39-183
• Hexagon bolt, 25 Nm