SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Parking lock: Removing and fitting >
< Slide box: general fitting diagram
Leon Mk2
Automatic gearbox 001
Automatic gearbox, gears, control
Slide box: removing and fitting
Slide box: removing and fitting
Slide box: removing and fitting
Slide box: removing and fitting
Replace the seal of the sealing screw.
–
Cut the seal
-arrow-
with a pair of cutting pliers, always replace the seal.
–
After the repairs, fit the plug by hand with a new o-ring and fill with ATF.
–
Fill with ATF, check ATF level and top up
Slide box identification
The code letters are stamped on the identification plate
-arrow-
. The identification plate should remain attached to the gearbox.
Removing and fitting solenoid -N93-
–
Remove bolt
-1-
and remove the valve cable.
–
Screw out bolts
-arrows-
.
–
Detach connector
-2-
.
–
Remove valve -N93-.
–
Replace the O-ring.
Install in reverse order.
Removal and assembly of support plate with solenoids -N88- to -N92-
–
Remove the solenoid -N93-
→ Anchor
.
–
Remove bolts
-A-
,
-B-
and
-C-
.
Installation is carried out in the reverse order. When installing, note the following:
–
Tighten bolts
-A-
-B-
and
-C-
to 8 Nm.
Removing and fitting the ATF strainer
–
Do not mix up bolts
-A-
and
-B-
; fit them in their original positions.
–
Tighten bolts
-A-
and
-B-
to 8 Nm.
–
Fit brackets
-1-
and
-2-
and plate
-3-
as described in the illustration.
Automatic gearbox 001
Automatic gearbox, gears, control
Slide box: removing and fitting
Slide box: removing and fitting
Parking lock: Removing and fitting >
< Slide box: general fitting diagram