Leon Mk2
| Differential: general fitting diagram |
| 1 - | Bolt |
| q | 30 Nm |
| 2 - | Torque converter casing |
| 3 - | Flanged shaft oil seal |
| q | Before fitting, fill the space between the sealing lips with universal grease |
| q | Removing and installing → Chapter |
| 4 - | Bolt |
| q | 22 Nm |
| q | Before installing, apply sealing paste → Spare parts catalogue |
| 5 - | Right hand side flanged shaft |
| q | Do not confuse the left and right flanged shafts as they are of different length |
| 6 - | Flanged shaft compression spring |
| 7 - | Thrust washer |
| q | Installation position: collar towards the spring, core towards the conical ring |
| 8 - | Conical ring |
| q | With slots for the thrust washer |
| q | Installation position: conical side facing the differential casing |
| 9 - | Circlip |
| q | The conical ring, the thrust washer and the compression spring all remain in place when the flanged or insert shaft is removed |
| 10 - | Articulation flange |
| q | Do not confuse the left and right flanged shafts as they are of different length |
| 11 - | Differential |
| q | Dismantling and assembling → Chapter |
| 12 - | Pin |
| q | To centre the gearbox casing and the torque converter |
| 13 - | Gearbox casing |
| q | Before assembling the gearbox casing and the torque converter, apply sealing compound → Spare parts catalogue onto the sealing surfaces |
| 14 - | Guide sleeve |
| q | For the speedometer control |
| 15 - | Speedometer control |
