Leon Mk2
Dismantling and assembling selector mechanism on vehicles before 06.01 |
Lubricate bearing positions and sliding surfaces with polycarbamide grease -G 052 142 A2-. |
1 - | Selector lever handle |
q | Removing and installing → Chapter. |
2 - | Sleeve |
q | Locates in the selector lever handle. |
q | Prevents the selector lever handle from being pulled off. |
3 - | Cover |
q | With selector scale, selector lever lock indicator and Tiptronic indicator. |
q | Removing upwards. |
4 - | Pull rod top part |
q | Removing and installing → Chapter. |
q | Allocate according to → Electronic parts catalogue “ETKA”. |
5 - | Bolt, 13 Nm |
q | For selector lever cable on selector mechanism. |
6 - | Selector mechanism with selector lever housing |
q | Removing and installing → Chapter. |
7 - | Selector lever cable |
q | Do not bend or kink. |
q | Checking and adjusting → Chapter. |
q | Removing and installing → Chapter. |
q | Do not grease ball socket. |
8 - | Seal |
q | Bonding to selector mechanism. |
9 - | Tunnel |
10 - | Frame |
11 - | Self-locking hexagon nut with collar, 10 Nm |
q | Qty. 4. |
q | Always renewing. |
12 - | Support bracket |
q | For selector lever cable to gearbox. |
13 - | Hexagon bolt, 13 Nm |
q | For support bracket. |
q | Qty. 3. |
14 - | Floor plate |
q | For seating retaining plate → Item. |
15 - | Lever |
q | For selector shaft. |
16 - | Retaining plate |
q | With seal. |
q | Attached to floor pan. |
17 - | Self-locking hexagon nut with collar, 5 Nm |
q | For securing retaining plate to floor pan. |
q | Always renewing. |
18 - | Locking cable |
q | For ignition key withdrawal lock. |
q | Must not be kinked. |
q | Removing and installing → Chapter. |
q | Adjusting → Chapter. |
q | Checking operation of ignition key withdrawal lock → Chapter. |
19 - | Bolt, 6 Nm |
q | For locking cable on selector mechanism. |
20 - | Steering lock |
21 - | Clip |
q | Location: Push on the clip from above. The angled ends of the clip point towards the steering lock. |