seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Torque settings > < Removing

Leon Mk2

Installing
Installing
Installation is performed in the reverse order of removal; when doing this, note the following:
–  Place selector mechanism into holder of tunnel.
   
–  Connect connector -arrow 3- of selector mechanism.
–  Press selector lever cable lock -arrows 2- together and push selector lever cable into support bracket of selector mechanism onto stop.
Selector lever cable lock must engage in support bracket.
–  Screw in bolt -arrow 1- of selector lever cable until finger-tight.
–  Hook locking cable on selector mechanism into locking lever → Chapter.
  N37-0831
–  Screw selector mechanism tightly onto tunnel using new nuts -arrows-.
–  Install front and middle heat shield above exhaust pipe.
–  Install catalytic converter if it was removed → Rep. Gr.26.
–  Adjust locking cable → Chapter.
–  Adjust selector lever cable → Chapter.
–  Install centre console → General body repairs, interior; Rep. Gr.68.
  N37-0833
–  Press frame -arrows- with cover and printed circuit board into selector mechanism.
–  Connect connector -1- of printed circuit board.
–  Install centre console trim → General body repairs, interior; Rep. Gr.68.
–  Install selector lever handle → Chapter.
–  Reconnect earth strap to battery.
–  Code radio → Radio, telephone, navigation; Rep. Gr.91.
–  Initialise electric windows and set clock → Booklet10.1.
  N37-0829

Torque settings > < Removing