SEAT Workshop Service and Repair Manuals

Window well seal inside the front door: Removing and installing Special tools and workshop equipment required

t  Release lever -T10039-

t  Lever -U 30800- t  Removing → Anchor t  Fitting → Anchor. Removing   WARNING Disconnect the battery earth strap before carrying out any work on the electrical system.   Note During removal and installation, take note of small amounts of deviations depending on the equipment. –  Remove the front door glass → Chapter.

–  Remove the inner trim -1- using the lever -U 30800-.

–  Unscrew bolts -1- and -2-. Both screws on the lower door section may only be loosened, but must not be unscrewed completely.

–  Unscrew the screws -2- securing the door lock. –  Remove the cap -3- using the lever -U 30800-. –  Remove lock cylinder housing → Chapter.

–  Remove the clip -1- of the door handle -2-.

–  Partially separate the subframe trim -1- from the door frame by first pushing the subframe in the direction of -arrow A- and then in the direction of -arrow B-.   Note It is not necessary to remove the trim of the subframe completely; partial separation is sufficient.

–  Remove the window well seal inside -1- using the wedge -T10039/1-, starting from the end -arrow A-. Fitting . Fit in reverse order from removal, remembering the following:

–  Attach the interior window seal -1- in the door flange, starting with the end -arrow A-. –  Press the entire surface of the interior window seal -1- evenly using the wedge -T10039/1-. –  Make sure that the entire surface of the window well seal is correctly in place in the door flange. Tightening torques → Chapter –  Door lock adjustment → Chapter.   WARNING Before mounting the door trims, the function of the components must be checked. → Chapter „Synchronisation and storage of window course“. → Chapter „Automatic raising or lowering: Commissioning“.