seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Front wing assembly > < Removing and installing front wing

Leon Mk2

Front wing removal
Front wing removal
–  Remove front bumper panelling → Chapter.
–  Remove wheel housing liner → Chapter.
–  Remove spacer → Chapter.
  Note
t  Given that the removal of the side indicators is only possible in one direction, do this carefully; with the indicator fitted, the side of the indicator in the allotment and elastic clip is not immediately clear.
t  If an attempt is made to lever the indicator off on the side of the elastic clip, the indicator or the paintwork may be damaged.
   
–  Carefully press the indicator with the lever -U 30800- on the side of the allotment -1-, overcoming the resistance of the plastic clip -2- from the other side of the indicator and extract it. (If necessary, cover the paintwork with adhesive tape).
–  Remove rubber bush with plug-in bulb from turn-signal housing
  N94-0289
–  Unscrew hex. head bolts -2- and -3-.
–  Heat wing at contact points with A-pillar with aid of hot air blower -SAT 1416- and remove (if necessary remove PVC with carpet knife).
–  Carefully remove front wing-1-.
  Note
t  The PVC underbody protector can only be lightly heated and for a short time PCB should not change colour or form bubbles.
t  To protect the front wing when supported on one of its parts, insert suitable material between wing and contact surface.

   

Front wing assembly > < Removing and installing front wing