SEAT Workshop Service and Repair Manuals

Bumper cover: front, removing and fitting

Special tools and workshop equipment required

t	Torque wrench kit -SAT 8010-

t	Kit (case) -T20017A-

t	Tray -T20173-

t	Lever -U 30800-

t  Remove the front bumper trim → Anchor t  Install the front bumper trim → Anchor Remove the front bumper trim   Note The wheel housing liners must not be removed for the removal of the front bumper trim. –  Open bonnet at front and hold in open position.

–  Remove the screws -1- for securing the upper part of the bumper trim -2-.

–  Remove the screws -arrows- for fixing the front wheel housing to the bumper trim.   Note If necessary, screw out another fixing screw of the wheel housing liner to make the following procedures easier.

–  Using the lever -U 30800-, push the front wheel housing -1- aside so that you can access the top screw -arrow- of the bumper trim.

–  Remove bolts -1-.

–  Remove the bumper trim. For this purpose, clip out the corners -arrow- and then push them forwards partially for accessing the plug to be removed.

–  Disconnect the connectors of the fog lamps -arrow-.

–  Disconnect the connector of the parking aid sender -arrow-.

–  Place the drip tray -T20173- under the washer fluid reservoir. –  Remove the clip from the headlight washer system.

–  Seal the motor of the headlamp washer system -1- using the plug from the kit (case) -T20017A-. –  Remove the trim of the bumper completely.   Note Always use a suitable material (e.g. Polyurethane mats) to protect the contact surface of the bumper trim. –  Place the bumper trim in a safe location. Install the front bumper trim Installation is done in reverse order of the removal operations; note the following: Tightening torques

Fixing screws of the bumper trim

2.0 Nm

–  Setting the fog lights (when fitted) → Electrical system; Rep. gr.94   Note t  Check the correct installation position of the front bumper trim: its correct position must be horizontal and parallel to the ground. t  Before closing front bonnet check the working of the Bowden cable lever.