Leon Mk2
Note
|
| The 4 markings for a bracket -1- can be found on the inside of the bumper cover. |
| – | If there are no markings, the centre point -2- must be determined. |
| – | The holes must be drilled from the inside to the outside with the drill in the tool kit -3-. |
| – | Fix the hole puncher in position with bolt head -1-, washer -2- and thrust bearing -3- from the inside of the bumper cover -5-. |
| – | Screw on punch -4-, not quite as far as bumper cover. |
| – | Press punch -4- against bumper cover. |
| – | Tighten hole puncher -1-. |
Note| The punch -4- must not turn on the paint of the bumper cover. |
| – | Pull the punch -4- through the material of the bumper cover -5--arrows- by turning the bolt head -1-. |
| – | Remove hole puncher and make the next holes. |
| – | Thoroughly clean bonding surfaces on bumper cover -4-. |
| – | Push bracket -2- onto centring pin -1-. |
| – | Pull protective backing off double-sided adhesive tape -3- on bracket. |
| – | Insert centring pin -1- into hole until the bracket is touching the bumper cover -4-. |
| – | Press bracket on forcefully in area of bonding surface -3-. |
| – | Removing centring pin and repeat the procedure for all brackets. |
| – | Further work is only carried out on bumper cover after minimum curing period → Chapter |
