Leon Mk2
Door handle and door lock - exploded view |
Note
Only the left side is shown. The procedures for the right-hand side are carried out analogue. |
1 - | Mounting bracket |
q | removing and fitting → Chapter |
2 - | Operating cable |
q | From door lock to bearing bracket. |
3 - | Operating cable |
q | From interior door handle to lock release. |
q | With grommet to passage on cover. |
4 - | Electrical connector |
5 - | Bolt. |
q | Tightening torque: 20 Nm |
q | 2 off |
6 - | Panel |
7 - | Door lock |
q | removing and fitting → Chapter |
8 - | Bolt. |
q | For lock cylinder. |
q | Tightening torque: 3.5 Nm |
9 - | Panel |
10 - | Bolt. |
q | Tightening torque: 1.5 Nm |
q | Bearing bracket is loosened from door when this bolt is loosened. |
11 - | Base |
12 - | Panel |
q | Removing and installing with lock cylinder → Chapter. |
q | Removing and installing without lock cylinder → Chapter. |
13 - | Door handle: |
q | removing and fitting → Chapter |
14 - | Lock cylinder |
q | removing and fitting → Chapter |
q | A lock cylinder can only be found in the driver door. |