Leon Mk2
| Rear window Exeo ST 2009: Assembly overview |
| Rear window Exeo ST 2009: general installation diagram. 1. Part |
| 1 - | Rear lid |
| q | removing and fitting → Chapter |
| 2 - | Spacers |
| q | 10 units |
| q | Dimensions: 6mm x 5.5mm x 25mm |
Note| If the spacer buffers loosen during the development, they must be attached with the markings in the ceramic(s) coating of the back window. |
| 3 - | Rear window |
| q | Remove the undamaged rear window → Chapter |
| q | Remove the damaged rear window → Chapter |
| q | Preparations for the assembly of the rear window → Chapter |
| q | Rear window: Fitting → Chapter |
| 4 - | Bead of glue |
| q | 1-K-Adhesives 180 ML -DH 009 100 A2- |
| q | 1-K-Adhesives 300 ML -DH 009 100- |
| q | 2-K-Adhesives 400 ML -DA 004 600 A2- |
| q | Cross-section of adhesive bead |
| t | Crawler width= 7 mm |
| t | Crawler height= 11 mm |
| 5 - | Body flange |
| 6 - | Centre guide |
| 7 - | Connection of the rear window heater. |
| 8 - | Adhesive stopper strip |
| 9 - | Side profile |
| q | 2 units |
| Rear window Exeo ST 2009: general installation diagram. 2. Part |
| 1 - | Rear window |
| q | Remove the undamaged rear window → Chapter |
| q | Remove the damaged rear window → Chapter |
| q | Preparations for the assembly of the rear window → Chapter |
| q | Rear window: Fitting → Chapter |
| 2 - | Bead of glue |
| q | 1-K-Adhesives 180 ML -DH 009 100 A2- |
| q | 1-K-Adhesives 300 ML -DH 009 100- |
| q | 2-K-Adhesives 400 ML -DA 004 600 A2- |
| q | Cross-section of adhesive bead |
| t | Crawler width= 7 mm |
| t | Crawler height= 11 mm |
| 3 - | Rear lid |
| q | removing and fitting → Chapter |
| 4 - | Spacers |
| q | 10 units |
| q | Dimensions: 6mm x 5.5mm x 25mm |
Note| If the spacer buffers loosen during the development, they must be attached with the markings in the ceramic(s) coating of the back window. |
| 5 - | Aerial connection |
| 6 - | Body flange |
| 7 - | Mounting pad |
| 8 - | Adhesive stopper strip |
