SEAT Workshop Service and Repair Manuals

Front door window - removing and assembly

Special tools and workshop equipment required

t	Torque wrench kit -SAT 8010-

t	Lever -T20043-

t	Lever -U 30800-

t  Removing → Anchor t  Fitting → Anchor. Removing Passenger's door:

–  Remove the cover -1- and the loudspeaker grille -2- using the lever -U 30800-.

–  Remove bolts -3-. –  Disconnect plug -2-. –  Detach the lining upholstery -1- from above using the lever -T20043-. –  Detach the lower fixing element by pulling upwards and remove the cover of the upholstery. Driver's door:

–  Remove the cover -1- and the loudspeaker grille -2- using the lever -U 30800-.

–  Unscrew the bolts -2- and remove the housing of the window lifter switch -1- using the lever -U 30800-. –  Remove the connector and detach the housing using the window lifter switch.

–  Remove bolts -2-. –  Detach the lining upholstery -1- from above using the lever -T20043-. –  Detach the lower fixings by pulling in the direction of the -arrows- and remove the cover of the upholstery. Continue for all doors.

–  Open or close the window until you can access the clamps -1-. –  Loosen the screws of the clamping jaws -1-. –  Move the window downwards until it is half opened.

–  Raise the rear section of the window -1- and turn to the front in the direction of the -arrow- to remove it from the guides -2-. –  Remove the window of the front door. Fitting. Fit in reverse order from removal, remembering the following:

–  Insert the window -1- in the direction of the -arrow- into the guides -2-.

–  Make sure that the window is located correctly in its mount in the door.

–  Press the window against the upper edge of the door frame -arrows-.

–  Pull the window to the clamping pieces and fit it on the door frame -arrows-.

–  Press firmly on the window and make sure the clamping pieces are reached and there is complete contact with the door frame -arrows-.

–  Tighten the screws -1- to a tightening torque of 9 Nm + 1 Nm+ 2,5 Nm. –  Connect the electric connector of the electric window switch. –  Switch ignition on. –  Make sure that the window can be opened and closed properly and easily. Tightening torques → Chapter   WARNING Before mounting the door trims, the function of the components must be checked. → Chapter „Synchronisation and storage of window course“. → Chapter „Automatic raising or lowering: Commissioning“.