–
| Cut back remaining material on body flange with U-shaped blade -V.A.G 1561/3-, but do not remove completely. |
Note The remaining material is required as a base for the new adhesive sealing material. Take care that the adhesive surfaces are clean (free of dust and grease). |
WARNING Exception: if bonding is performed later than one day after cutting back adhesive bead, the remaining residual material must be activated with activator. |
Apply activator evenly in one stroke using applicator. |
Activator must not come in contact with paint, or the paintwork will be damaged. |
Drying time, approx. 10 minutes |
|
t
| If the window flange has been repaired or partially renewed, the area concerned must be cleaned and primed again after painting. |
Note It is possible that a laser weld seam lies outside the area of the adhesive bead. In this case, the exposed weld seam must be sealed with glass adhesive before bonding the window. |
|
|
|