–
| Position window shaft seal -3- on door and press in each mounting clip -2- with aid of flat screwdriver and turn 90º, until groove is in a vertical position. |
Caution Install window guide uniformly without bending. |
The inner part of the window guide is metal. If it is bent, it is not possible to return it to the original shape. |
|
–
| Install part of window guide removed: For this purpose first press end of guide in until it catches in the outer window shaft seal - the groove on the retaining wedge for the window guide must be flush with the door frame. |
–
| Press forcefully against the window guide at the height of the retaining wedge. If necessary drive in retaining wedge for window guide completely with aid of rubber hammer. |
–
| Continue to install window guide in direction of upper rear edge of door frame in the same manner until it is completely arrested in the door frame. |
|
|
|