–
| Apply adhesive using the window sealant gun -SAT 5350- or window dual-component glue gun -VAS 5237- around the window perimeter, onto the primer coat -1- or onto the trimmed bead of adhesive, at right angles to the glass. |
WARNING The glass must be fitted before 10 minutes elapse, as the adhesive properties of the glue are reduced after that time. |
|
–
| Insert the windscreen with two syphon -VAG 1344- used in disc cut-out, determine and apply up to the distance between piers. |
–
| Check the window glass clearances → Chapter. |
–
| During the hardening time, fix the windscreen with adhesive tape. |
When the glue is dry → Chapter, fit the following: |
Note If the adhesive bead has been applied too thickly, and the adhesive overflows, the adhesive is to be removed after drying. |
|
|
|