| t
| Before removing the retaining strip, warm it with hot air blower -V.A.G 1416-. |
| t
| If the retaining strip is removed and reinstalled, only use adhesive remover -D 002 000 10- to remove the residual adhesive. |
| t
| Ensure that the adhesive surfaces are free of dust and grease. |
| t
| The lettering must be bonded in place immediately after cleaning. |
| t
| Remove protective backing immediately before installation. |
| t
| When applying, the temperature should be about 21 °C. |
| t
| Lettering cannot be removed without damage. |
|
|
|
