Leon Mk2
Installation |
Note
t | New bolts must always be used when installing glass panel. |
t | To screw in bolts, use a magnetic tool so that bolts do not fall into panoramic sliding roof guide. |
– | Insert glass panel -1- from above and screw in screws -2- but do not tighten them firmly. |
– | Adjusting front glass panel → Chapter. |
– | Tighten bolts -2- to tightening torque 5 Nm. |
– | Fit trim -2- into glass panel at front -1--5-. |
– | Push trim -2- towards the rear -arrow A-. |
– | Push trim onto glass panel -arrow B- and clip locking lugs -4- in on the rear. |
– | On completion of all work, operate sliding roof motor to establish reference points → Chapter. |