Leon Mk2
| Installing exterior seal |
Note| t | New seal is supplied in excess length. The new seal must be cut to length appropriately. It is recommended to leave new seal 1-2 mm longer than it should be and to compress any excess length. |
| t | To guarantee a good bonding of seal, do not bond at a temperature below 20°. |
| t | After bonding outer seal, wait at least 30 min before fitting glass panel to ensure seal does not unstick. |
| – | Entire bonding surface on roof cut-out must be free of dust and grease. |
| – | Clean complete bonding area with cleaning solution -D 009 401 04-. |
| – | Centre new exterior seal -1- with joint -arrow- to centre of rear roof cut-out. |
| – | Pull protective film from adhesive tape -3- of new exterior seal -1- and press seal onto roof -3-. |
| – | The seal must not pull into the radii, otherwise the seal will stretch and compress. |
| – | Press exterior seal on firmly and evenly 2x around circumference using roller -3356-. |
| – | Install rear glass panel → Chapter. |
| – | Install front glass panel → Chapter. |
