seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Crash sensors > < Rear side impact sensor: removing

Leon Mk2

Rear side impact sensor: fitting
Rear side impact sensor: fitting
  Note
t  When the sensors are replaced, it is necessary to replace them with others of the same position, given that the front and rear sensors have a specific programming index.
t  The assembly position in the vehicle is defined by an arrow which should indicate the outside of the vehicle.
Continue the assembly in the reverse order to removal, remembering to:
–  Switch off all electrical components.
–  Switch ignition on.
–  Close the doors.
  WARNING
On connecting the battery earth cable, ensure that there is no-one inside the vehicle .
–  Connect battery earth cable.
  Note
   
If, after assembly, the airbag warning light -K75- lights up, the fault memory must be erased using the central diagnosis -VAS 505X-. After erasing the memory, consult the fault memory again .
  E69-10069

Crash sensors > < Rear side impact sensor: removing