Leon Mk2
| Lock carrier - service position 06.00 > |
Note| The removal and installation procedures may have to be modified slightly depending on equipment variants. |
| The lock carrier service position is intended to improve access to the engine compartment. |
| – | Remove front bumper cover → Chapter. |
| – | Remove noise insulation → Chapter. |
| – | Unhook Bowden cable -3- from lock. |
| – | Remove windscreen wiper reservoir -4- and fuse holder -5- from lock carrier -1-. |
| – | Unscrew one bolt -6- (specified torque = 30 Nm) from each from the longitudinal members. Use the special tool -T 10093- which is to be screwed into left and right longitudinal members. |
| – | Remove bolts -2- (specified torque = 8 Nm) and -6- (specified torque = 30 Nm) and pull lock carrier -1- forwards at guide pins -T 10093- in -direction of arrow-. |
