Leon Mk2
| Assembly overview - lock cylinder |
| 1 - | Seal |
| 2 - | Handle |
| 3 - | Guide sleeves |
| 4 - | Grip moulding |
| 5 - | Retaining clip |
| 6 - | Shaft |
| 7 - | Locking ring |
| 8 - | Spring |
| 9 - | Seal |
| 10 - | Retaining clip |
| 11 - | Contact switch on lock cylinder housing for rear lid/anti-theft alarm system/central locking -F 124- |
| 12 - | Lock cylinder housing |
| q | Removal: |
| – | Remove rear lid trim: → General body repairs, interior; Rep. gr.70. |
| – | Disconnect connections. |
| – | Prise out retaining clip -5-. |
| – | Unscrew bolts -17- and remove lock cylinder housing from handle. |
| – | Observe sealing requirements. |
| q | Installation: |
| – | Unscrew bolt and take handle out of lid. |
| – | Insert securing clip -5- into the handle. |
| – | Install handle, tighten bolt. |
| – | Insert lock cylinder housing into handle and engage. |
| – | Tighten bolts -17-. |
| 13 - | Contact switch on lock cylinder housing for rear lid/anti-theft alarm system/central locking -F 124- |
| 14 - | Retaining clip |
| 15 - | Retaining clip |
| 16 - | Spring |
| 17 - | Bolt |
| q | 6 Nm |
