Leon Mk2
| Installation |
Note| t | Pull adhesive tape off new roof edge spoiler -1- just before applying adhesive material. |
| t | Roof edge spoiler -1- is fitted with magnets to ease assembly. |
| l | Preparing body kit component for bonding → Chapter. |
| l | Installation instructions → Chapter. |
| l | Minimum curing period → Chapter. |
| l | Touching up paintwork damage → Chapter. |
| l | Cleaning off excess adhesive sealing material → Chapter. |
| – | Thoroughly clean rear lid -4- in area of contact surfaces for roof edge spoiler -1-. |
| – | Position roof edge spoiler -1- and check fitting. Mark position using suitable materials. |
| – | Apply primer to priming surface -3- on rear lid -4-, width 20 mm. |
| – | Apply adhesive bead to primed area -2- on roof edge spoiler -1-. |
| – | Place roof edge spoiler -1- onto rear lid -2-. |
| – | Align roof edge spoiler -1- on rear lid -2- and forcefully press roof edge spoiler -1- onto rear lid. |
| – | Secure roof edge spoiler -1- on rear lid -2- using a suitable adhesive tape -3- until adhesive has cured. |
WARNING
|
