| 1 - | Glass scraper (commercially available) |
| 2 - | Blade (commercially available) |
| –
| Remove retaining plate from mirror base. |
| –
| Remove PUR adhesive from mirror base using a wire brush. |
| –
| Grind off the three spacer protrusions on bonding surface. To do this, use sandpaper (360/400 grain) laid on flat surface. |
| –
| Keep sanded surface clean and free of grease. |
| –
| Scrape down PUR adhesive material and primer down to ceramic layer on windscreen using glass scraper. |
| –
| Clean bonding area with adhesive remover D 002 000 10 or cleaning solution D 009 401 04. |
Caution | Do not damage ceramic coating. Scratches will remain permanently visible. |
|
| –
| Cut nylon mesh fabric exactly to size of mirror base. |
Note | Wear hand protection (rubber gloves). |
| –
| Apply adhesive evenly and smoothly to base of mirror. |
| –
| Fit nylon mesh fabric onto base of mirror. |
| –
| Apply further adhesive to nylon mesh fabric by dabbing with tube. |
| After adhesive has been applied to nylon mesh fabric, base of mirror must be pressed onto windscreen within 30 seconds. |
| –
| Press base of mirror firmly (do not use force) against windscreen for 15 seconds. |
| –
| Remove excess adhesive with a cloth. |
Note | Interior mirror can be installed after 15 minutes. |
|
|
|
