SEAT Workshop Service and Repair Manuals

Cover and padding for 1/3 rear seat backrest, left side: Removing and installing. Special tools and workshop equipment required

t  Hook -3438-

t  Release lever -U 30800-

t  Thrust piece -T20069- Removal: –  Remove the 1/3 section of rear seat backrest, left side → Chapter. –  Remove the rear seat backrest head restraint 1/3, left-side → Chapter. –  Remove the 1/3 section of rear seat backrest head restraints, left side → Chapter. –  Remove the release lever of the rear seat backrest → Chapter.

–  Hang-out the profile -1- of the frame -2- using the lever -U30800-.

–  Remove the cover -1- from the padding -2- until you can see the wire -3-. –  Loosen the wire -3- from clamps -arrow A- and -arrow B- using the pressure tool -T20069-. –  Remove the wire -3- from its mount -arrow C- and -arrow D-.

–  Remove the cover -2- from the padding -1- until you can see the wire -3-. –  Loosen the wire -3- from the clamp -arrow B- using the pressure tool -T20069-. –  Loosen the wire -3- from its mount -arrow C- using the hook -3438-. –  Loosen the wire -3- from its mount -arrow A-. –  Loosen the wire -3- from its mount -arrow C- using the hook -3438-. –  Loosen the wire -3- from its mount -arrow A-.

–  Remove the cover -2- from the padding -1- until you can see the wire -3-. –  Loosen the wire -3- from the clamp -arrow B- using the pressure tool -T20069-. –  Loosen the wire -3- from its mount -arrow C- using the hook -3438-. –  Loosen the wire -3- from its mount -arrow A- and remove the cover -2-.

Installation –  Insert the wire -3- into its mount -arrow A-. –  Fix the wire -3- to the clamp -arrow B- using the pressure tool -T20069-. –  Fix the wire -3- to its mount -arrow C- using the hook -3438-. –  Fix the wire -3- to its mount -arrow C- using the hook -3438-.

–  Insert the wire -3- into its mount -arrow A-. –  Fix the wire -3- to the clamp -arrow B- using the pressure tool -T20069-. –  Fix the wire -3- to its mount -arrow C- using the hook -3438-.

–  Insert the wire -3- into its mounts -arrow C- and -arrow D-. –  Fix the wire -3- into clamps -arrow A- and -arrow B- using the pressure tool -T20069-. –  Mount the cover -1- onto the padding -2-. –  Install the release lever of the rear seat backrest → Chapter. –  Install the rear seat backrest head restraint guides 1/3, left-side → Chapter

–  Engage the profile -1- of the rear part of the entire scope using the lever -U30800-. –  Install the rear seat backrest 1/3, left-side → Chapter. –  Install the rear seat backrest head restraint 1/3, left-side → Chapter.