Leon Mk2
|
| 1 - | Trim |
| q | Clipped |
| 2 - | Cross-head screw |
| q | 2.5 Nm |
| 3 - | Switch trim |
| q | Switch for rear electric window regulator |
| 4 - | Trim panel |
| q | Removing: |
| – | Unclip cover → Item |
| – | Remove cross-head screw → Item |
| – | Starting from bottom, unclip trim off door using release lever -T10039- and wedge -T10039/1- and take out of window aperture upwards |
| – | Disconnect connectors for electric window regulators, loudspeakers and interior door light |
| 5 - | Spreader nut |
| q | Before installing trim, clip into mounting hole in door |
| 6 - | Clip |
| q | Before installing trim, insert in clip holders → Item and in clip supports → Item |
| 7 - | Insulation film |
| q | Removing and installing → Chapter |
| 8 - | Interior door light |
| q | Lever out to remove and separate connector |
| 9 - | Mounting for clip |
| 10 - | Clip holder |
| q | Securely bonded to trim |
| q | If clip holders have worked loose off trim, these can be bonded back into position using 2-pack adhesive material -D 173 KD2 A1- |
| 11 - | Cover |
| q | Clipped |
