Leon Mk2
| Rear door lining fitted with manual window lifter: Removing and installing. |
| Special tools and workshop equipment required |
| t | Torque wrench kit -SAT 8010- |
| t | Release lever -T20043- |
| t | Release lever -U 30800- |
Note
|
|
|
| – | Release cover on door handle -12- with lever -U 30800-. |
| – | Unscrew the bolts -10- and -11-. |
| – | Use the lever -T20043- to detach the window unit -9-. |
| – | Remove the multi-pin connector -6- located on the B-pillar. |
| – | Insert the multi-pin connector -6- together with the rubber bellows inside the door frame. |
| – | Remove the window in the rear door → Bodywork exterior fitting work; Rep. gr.64. |
| – | Unscrew the bolt -3-. |
| – | Unscrew the bolt -5-. |
| – | Loosen bolt -8- without fully removing. |
| – | Separate trim -4- from door frame. For this purpose first press upward and release bottom of guide on window lifter from door frame. |
| – | Lower the lining -4- until releasing the upper part of the window raiser guide from the door frame. |
| – | Detach trim -4-. |
| – | Disconnect the lock connector -5-. |
| – | Open the cover -6- turning it in the direction of -arrow A-. |
| – | Detach the retainer hooks -2- turning in the direction of -arrow B-. |
| – | Pull the Bowden cable -3- in the direction of -arrow C- and remove the interlocking from the guide in the door lining. |
| – | Remove the hook -1- from the handle attachment |
| – | Remove the Bowden cable -3- from the attachment to the door lining -4-. |
Note
|
Note
|
|
